Dalsa HM1400 XDR Manual de usuario descargar pdf (Pagina 12)

10 • Genie HM Series Overview Genie HM Series-GigE Vision Camera

Camera Performance Specifications

Specifications for each available sensor are listed after the general Genie camera specifications.

Camera Controls

Synchronization Modes Free running

External triggered

Software trigger (through Ethernet)

Exposure Modes Programmable in increments of 1µs

minimum 10µs in Reset Mode or 56µs in Synchronous Mode

maximum is 4 seconds

Pulse controlled via Trigger pulse width.

Trigger Input Opto-isolated, 2V to 12V typical, 2mA min.

Debounce range from 1µs up to 255µs

Strobe Output

Output opto-isolated:

Aligned to the start of exposure with a programmable delay, duration and polarity

Features

LUT 8-bit (all models) / 10-bit (only HM1400 and HM1400 XDR)

Flip Real-time horizontal flip

Binning Digitally based: Horizontal (2 pixel) and Vertical (2 line)

Timestamp 1µs internal timer or external signal to timestamp images and events

Test image Internal generator with choice of static and shifting patterns

User settings Select factory default or one user camera configuration

Optical Interface

Back Focal Distance—C-Mount 17.52 mm

Back Focal Distance—CS-Mount 12.52 mm

Mechanical Interface

Camera Size 29(H) x 44(W) x 67(L) in mm, ( see Mechanical Specifications )

Mass < 125g (no lens)

Power connector 12 pin male Hirose

Ethernet connector RJ45

Electrical Interface

Input Voltage xx-GM0x-xxxxx models +11 to +25.2 Volts DC at 0.6 Amp minimum

(over voltage–reverse voltage protected)

xx-GENx-xxxxx models +11 to +15.2 Volts DC at 0.6 Amp minimum (legacy models)

Power Dissipation < 4W

Operating Temperature 0 to 45°C (at front plate)

Relative Humidity 5% to 90% non-condensing (operating)

Output Data Configuration Gigabit Ethernet (IEEE 802.3)

Data and Control GigE Vision compliant at 1000 or 100 Mbps

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 156 157

Sin comentarios

Dalsa HM1400 XDR Manual de usuario Pagina 12